HI ROLLER - BELT CONVEYORS 8. TROUBLESHOOTING
HI ROLLER, MINI ROLLER, LO ROLLER & HI LIFE
P115506 R3 123
28. Start-up problems. • head pulley slippage • cleaning system failure, material
build up is causing extreme belt
pull requirements - system must
be cleaned
• moisture must be eliminated
29. Tracking. • belt is tracking well
empty, but tracking is
to one side when
loaded
• loading problems, side flows will
push belt to the side - see Sec-
tion 4.6.
• belt misalignment • loading problems - bi-directional
loaders require a special design,
contact Hi Roller engineering
• loading problems - control gate
not proper installed, see Section
4.6.
• loading problems - flow of mate-
rial is not directed down the back-
plate of the loader, see Section
4.6.
• loading problems - flow of mate-
rial is not evenly flowing down the
loader back place, see Section
4.6.
• loading problems - side flows will
push belt to the side, see Section
4.6.
30. V-plow. • splice hitting in tail sec-
tion
• the v-plow must be adjusted
properly - see “V-Plow Adjust-
ment” on page 52
Problem Effect Solution
To Next Page
Loading...
