Agilent Technologies 33522A Service Guide

70
Chapter 3 Front-Panel Menu Operation
To Output a Burst Waveform
3
2 Select the burst mode.
Press
and then press the Burst Off / On softkey. Notice that a
status message “N Cycle Burst, Trig Imm” is shown in the tab of the
current channel.
3 Set the burst count.
Press the # of Cycles softkey and then set the count to “3” using the
numeric keypad or knob. Press the Enter softkey to finish data entry if
you are using the numeric keypad.

Agilent Technologies 33522A Specifications

General

Brand	Agilent Technologies
Model	33522A
Category	Laboratory Equipment
Language	English