Agilent Technologies 4156b

Agilent 4155B/4156B User’s Guide Vol.2, Edition 5 4-39
Making a Measurement
Knob Sweep Measurements
To Stop Knob Sweep Measurement
To stop the knob sweep measurement, press Stop front-panel key.
This returns the 4155B/4156B operation state to the previous state. For example, if
the knob sweep measurement starts from the idle state, the operation state returns to
the idle state.
Starting knob sweep again
To start the knob sweep measurement again, press the following front-panel key:
Single The knob sweep measurement will start from the point where it
was stopped.
Green, Single The knob sweep measurement will start from 0 V or 0 A.