5-22 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
Analyzing Measurement Results
Manual Analysis
To Overlay an Internal Memory Measurement Curve
onto Plotting Area
This section explains how to overlay a measurement curve (that was stored into an
internal memory) onto plotting area. To store a measurement curve into an internal
memory, refer to Chapter 3 of User's Guide General Information.
1. Select DISPLAY SETUP primary softkey.
2. Set OVERLAY PLANE secondary softkey to the desired memory number.
Selected measurement curve is overlaid onto plotting area. Selecting
OVERLAY PLANE secondary softkey toggles as follows:
OFF ® 1 ® 2 ® 3 ® 4 ® OFF
To display information of overlay measurement curve
Select SHOW OVERLAY INFO secondary softkey. The following information of
overlay measurement curve overwrites the information of the present curve.
• axis names and axis scales
• cursor and marker coordinates, line x-, y1-, y2-interrupt and gradient
• data variables
To display information of original curve again, select the EXIT primary softkey.
To change the present scale to the same scale as overlay curve
Select SCALE TO OVERLAY secondary softkey.
To return to the original scale, you need to select SCALING primary softkey, then
select CANCEL SCALING secondary softkey.
To Next Page
Loading...
Need help?
General
