Agilent Technologies 53181A - Page 137

Chapter 2 Operating Your Frequency Counter
Preset Values After Power-up and *RST
Operating Guide 2-69
2
Channel 1 auto trigger yes ON ON no
Channel 1 trigger level (volts) yes 0.000V
1
0.000V
1
no
Channel 1 trigger level (percent) yes 50% 50% no
Channel 1 trigger slope yes POS POS no
Channel 1 sensitivity yes 100% HIGH no
Measurement Control
Parameters
Run/Single selection yes SINGLE RUN
2
no
Math Operation Parameters
Math on/off yes OFF OFF no
Scale yes 1.000000 1.000000 no
Offset yes 0.0000000000 0.0000000000 no
Limits Parameters
Limit test on/off yes OFF OFF no
On fail stop/go on yes GO ON GO ON no
Lower limit yes 0.0000000000 0.0000000000 no
Upper limit yes 0.0000000000 0.0000000000 no
Limit display number/graph yes NUMBER NUMBER no
Stats Parameters
Stats on/off yes OFF OFF no
Stats measurement count, N yes 100 100 no
Display measurement/stats yes MEAS MEAS no
Stats use all/in limits yes USE ALL USE ALL no
On-single measurement count yes 1 (AUTO OFF) 1 (AUTO OFF) no
Print Parameters
Table 2-6. Agilent 53181A Preset Values (continued)
Description In Save/Recall
Value at *RST
(GPIB Reset)
Value at Power-
Up
In Non-Volatile
Memory