Contents
Contents-2
To change input impedance and input coupling 3-12
To adjust the analog channel’s vertical scale and offset 3-13
To adjust digital channel’s vertical size and offset 3-14
To adjust sweep speed and horizontal position 3-15
To magnify a part of the waveform using delayed sweep 3-16
To set the oscilloscope to trigger on an edge 3-17
To use the markers 3-18
To use the quick measurements 3-19
To reinitialize the oscilloscope 3-20
Full-Screen Mode 3-21
Graphical Interface Mode 3-23
Measurement Toolbar 3-25
Tab Display Area 3-26
Waveform Display Area 3-26
Menu Control and Menus 3-27
Vertical Settings and Controls 3-27
Horizontal and Trigger Toolbar 3-28
To switch between the graphical interface and full-screen mode 3-30
To perform basic user interface operations 3-31
To select a command from the menu bar 3-33
To select a command from a context-sensitive menu 3-34
To change the mouse settings 3-36
To start and stop waveform acquisition 3-37
To clear the waveform display 3-38
To print the screen 3-39
To turn a channel on or off 3-40
To adjust the vertical offset 3-41
To adjust vertical scaling 3-43
To access the channel setup 3-44
To set the horizontal reference point 3-45
To adjust sweep speed 3-46
To adjust horizontal position 3-47
To access the horizontal setup 3-48
To zoom on a section of the waveform 3-49
To move the markers using the graphical interface 3-51
To make a measurement on a waveform 3-52
To access the trigger setup 3-54
To set an edge trigger 3-55
To set dialog box preferences 3-56
To install the printer software 3-59
To set up the network 3-67
To recover your Infiniium hard disk 3-68
To Next Page
Loading...
Need help?
General
