Agilent Technologies 54830 Series - Graphical Interface Mode

Using the Oscilloscope
Graphical Interface Mode
3-23
Graphical Interface Mode
Click the graphical interface enable button to switch to the graphical interface.
When the graphical interface is enabled, the display looks like the following two
figures. See “To switch between the graphical interface and full-screen mode”
on page 3-30.
Figure 3-17
Infiniium Oscilloscope Top of Display in Graphical Interface Mode
This button enables
the graphical
interface
Menu bar
Measurement
toolbar
(can be turned
off)
Set vertical
scaling
Turn this
channel
on or off
Access the
Channel Setup
dialog box
Memory bar—
highlighted area shows
how much of
acquisition memory is
displayed on the screen
Click here to set the
time and date