Contents
Contents-1
1 Setting Up the Oscilloscope
To inspect package contents 1-3
To inspect options and accessories 1-5
To connect power 1-7
To connect the mouse or other pointing device 1-11
To connect the keyboard 1-12
To connect to the LAN card 1-13
To connect oscilloscope probes 1-14
To connect the digital probe 1-17
Digital probe lead set 1-18
Probe tip isolation network and equivalent load 1-18
Direct connection through 40-pin connector 1-20
To connect a printer 1-22
To connect an external monitor 1-25
To connect an GPIB cable 1-26
To tilt the oscilloscope upward for easier viewing 1-27
To turn on the oscilloscope 1-28
To turn off the oscilloscope 1-29
To verify basic oscilloscope operation 1-30
To clean the oscilloscope 1-32
2 Working in Comfort
About Repetitive Strain Injury 2-3
Mice and Other Input Devices 2-4
3 Using the Oscilloscope
Front Panel 3-4
Acquisition and General Controls 3-5
Horizontal Controls 3-5
Trigger Controls 3-5
Vertical Controls 3-5
Marker and Measurement Controls 3-6
To set the oscilloscope to a known starting condition 3-7
To start and stop waveform acquisition 3-8
To clear the waveform display 3-9
To turn an analog channel on or off 3-10
To turn digital channels on or off 3-11
!
!
To Next Page
Loading...
