74
Using the Agilent 81101A
Warnings and Errors
8
Increase the pulse width further to approximately 980 ns and press
HELP to see the current warnings:
W
IDTH
1
TOO
CLOSE
TO
PERIOD
T
RAILING
EDGE
1
MAY
CUT
NEXT
PULSE
9
Press HELP again to return to the W
IDTH
parameter.
10
Increase the pulse width further until a flashing error message
appears (approximately 1.10
µ
s):
OUTPUT 1: W
IDTH
> P
ERIOD
You have reached the current upper error-limit of the W
IDTH
parameter.
The setting is not implemented in the output hardware.
11
Press SHIFT + HELP to perform an AUTOSET.
To Next Page
Loading...
