366 Chapter6
Programming Command Cross Reference
Programming Command Versus Front Panel Key
IF IF THEN ELSE ENDIF forms a decision and branching
construct.
INT Places the greatest integer that is less than or equal to the
source value into the destination.
KEYCLR Clears softkeys 1 through 6.
KEYDEF Assigns a label and user-defined function to a softkey.
LCLVAR Defines a local variable for use within a downloadable program.
LIMD Enters the delta amplitude value for a limit-line segment.
LIMF Enters the frequency value for a limit-line segment.
LIMIFAIL Returns a "0" if the last measurement sweep of trace A is equal
to or within the limit-line bounds.
LIMIPURGE Disposes of the current limit line, but not the limit-line table.
LIMIRCL Recalls a limit line table from module memory.
LIMIREL Specifies a relative limit line.
LIMISAV Saves the current limit-line table in module memory.
LIMITEST Compares trace A with the current limit-line data.
LIML Assigns an amplitude value to a limit-line segment in the lower
limit line.
LIMM Assigns a middle amplitude value to a limit-line segment.
LIMTFL Specifies a flat limit-line segment.
LIMTSL Specifies a sloped limit-line segment.
LIMU Assigns an amplitude value to a limit-line segment in the upper
limit line.
LOG Takes the logarithm (base 10) of the source, multiplies the
result by the scaling factor, then stores it in the destination.
MEAN Returns the mean value of the given trace in measurement
units.
MEM Returns the amount of spectrum analyzer memory available.
MENU Selects and displays the softkey menus on the spectrum
analyzer screen.
MIN Compares source 1 and 2, point by point, and stores the lesser
of the two in the destination.
MOD Stores the remainder from the division of source 1 by source 2
in the destination.
MODRCLT Recalls the trace from module memory.
MODSAVT Saves the trace in module memory.
MOV Copies the source values into the destination.
MPY Multiplies the sources, point by point, and places the results in
the destination.
MSDEV Specifies the mass storage device.
MXM Compares source 1 and source 2, point by point, sending the
greater value of each comparison to the destination.
ONEOS Executes the list of analyzer commands after the end of the
sweep.
Table 6-4 Mass Memory Module Commands
To Next Page
Loading...
Need help?
General
