Agilent Technologies 8562EC User Manual

Chapter 7 493
Language Reference
IDCF Signal Identification to Center Frequency
IDCF Signal Identification to Center
Frequency
Syntax
Figure 7-140 IDCF Syntax
Description
The IDCF command sets the center frequency to the frequency obtained
from the command SIGID. SIGID must be in AUTO mode and have
found a valid result for this command to execute properly. Use SIGID
on signals when in external mixing mode. IDCF only applies to
spectrum analyzers with firmware revisions ≤920528 or with Option
008. The command does not apply to an 8560E/EC Option 002 or when
the spectrum analyzer is configured to use preselected external mixers.
Example
10 OUTPUT 718;"SIGID AUTO;"
20 OUTPUT 718;"IDCF;"
30 OUTPUT 718;"CF?;"
40 ENTER 718;Cf
50 PRINT Cf
60 END

Agilent Technologies 8562EC Specifications

General

Brand	Agilent Technologies
Model	8562EC
Category	Measuring Instruments
Language	English