Agilent Technologies 8562EC User Manual

Chapter 7 407
Language Reference
ADJALL LO and IF Adjustments
ADJALL LO and IF Adjustments
Syntax
Figure 7-40 ADJALL Syntax
Description
The ADJALL command activates the RF local oscillator (LO) and
intermediate frequency (IF) alignment routines. These are the same
routines that occur when the spectrum analyzer is switched on.
Commands following ADJALL are not executed until after the analyzer
has finished the alignment routines.
Example
10 OUTPUT 718;"ADJALL;"
20 END

Agilent Technologies 8562EC Specifications

General

Brand	Agilent Technologies
Model	8562EC
Category	Measuring Instruments
Language	English