Appendix B 129
SCPI Command Reference
:CALC{1-4}:TRAN:TIME:CLOS
:CALC{1-4}:TRAN:TIME:CLOS
Syntax :CALCulate{[1]|2|3|4}[:SELected]:TRANsform:TIME:CLOSs <numeric>
:CALCulate{[1]|2|3|4}[:SELected]:TRANsform:TIME:CLOSs?
Description For the active trace of channel 1 (:CALC1) to channel 4 (:CALC4), sets the center value
used for the transformation function of the fault location function.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Example of use 10 OUTPUT 717;":CALC1:TRAN:DIST:CLOS 100"
20 OUTPUT 717;":CALC1:TRAN:DIST:CLOS?"
30 ENTER 717;A
Related commands :CALC{1-4}:TRAN:DIST:CLOS on page 114
:CALC{1-4}:TRAN:METH on page 126
Equivalent key [Analysis] - Fault Location - Cable Loss
<numeric>
Description Cable Loss value
Range Varies depending on the frequency span and the number of
points.
Preset value 0
Unit dB/usec
To Next Page
Loading...
