19
OVERVIEW
Used in conjunction with the PRE/POST-ROLL function and CYCLE, you can cycle
round the IN/OUT points with the PRE-POST-ROLL offsets to repeatedly rehearse a
take - when you ready, press PLAY+RECORD (or the footswitch) to commit the record-
ing.
For example, if the IN time is set to 00:01:00:00 and the OUT time is set to 00:01:20:00,
with PRE-ROLL and POST ROLL set to 5 seconds each, with CYCLE switched on, the
DPS24 will play around 00:00:55:00 to 00:01:25:00 switching monitoring/punching in/
out at 00:01:00:00 and 00:01:20:00 respectively. To hear the recording, you should switch
AUTO off.
FADER BANK Selects which channels the 12 ’physical’ channels will control.
INP MON Switches selected inputs to monitor. When INPUT MONITOR is switched off (the de-
fault), monitoring is as follows on the selected RECORD tracks:
PLAYBACK Monitor disk
RECORD Monitor input
STOP Monitor input
Thus, when playing up to a record punch-in (manual or automatic), you hear the track(s)
selected for record playing back. At the point of the punch-in, monitoring switches to
INPUT and you will hear what you are playing/recording. At the point of punch-out,
monitoring reverts to disk playback. When playback is stopped, you hear the inputs.
When INPUT MONITOR is switched on, you hear the inputs through the tracks se-
lected for record at all times (i.e. during playback, recording and when the DPS24 is
stopped).
WHEEL Turns the JOG/SHUTTLE wheel on or off.
CANCEL Cancels/aborts prompt driven actions (for example, editing, deleting, naming, scene
recall, autolocate recall, etc.).
ENTER Proceeds with any prompt driven actions about to take place (for example, editing, de-
leting, naming, scene recall, autolocate recall, etc.).
➸
NOTE :
Cancel and Execute are also shown on the LCD in such circumstances. The dedicated keys are
provided for convenience when using functions such as scene and/or autolocate recall, etc., where it may not be
convenient to reach up to the LCD.
To Next Page
Loading...
Need help?
General
