Chapter 8: Mixer Functions
Page 134
Setting the Volume or Pan for Each Note
Up to this section the volume or pan settings were set by displaying them together for each pad
bank. It is also possible to display a list of parameters for each note.
Hold down SHIFT and press MIXER (numeric key 7), then select “DRUM 1-4”.
The mixer display will appear.
Select one of the channels with the drum pads or CURSOR LEFT/RIGHT keys, press OPEN
WINDOW and the “Channel Settings” screen will appear.
........................
......................................................................................................
.........................................................................................................
............................
CLOSE
Channel SettingsChannel Settings
Note:42/A03-OFF
STEREO INDVI FX Follow
Vol:100 Vol: 100 34 stereo:
Pan:MID Out: - -- No
.....................................................................................................
................
Select the Note: field with the CURSOR key and select the note you want to edit with the DATA
wheel. The assigned sound name appears to the right of the note number. It is also possible to
directly select by hitting the drum pad.
The left-hand part of the screen:
STEREO to set the volume and pan of the rear panel STEREO OUT outputs.
The right-hand part of the screen:
INDIV to select the individual output jack and volume level (if the optional board is installed).
FX to select an effect and set the effect send level.
Follow stereo: If set to YES, the individual out and effect send levels will be changed
when the stereo output mixer level is changed.
If set to NO, the individual out and effect send levels will not be affected when the stereo output
mixer level is changed.
To Next Page
Loading...
Need help?
General
