Akai MPC2000XL

Page 40
Chapter 3: Recording Sequences
Setting the Time Correct (Quantization)
When data is recorded to a sequence in real-time, the note event is time corrected to the value
specified here.
Also, when the bar, beat, or tick point is moved using the STEP < / > key, the value specified here
is used.
.......................................................
..................................................................................................
Sq:01-(Sequence01)
TrMUTE SOLO Tr +
Now:001.01.00
STEP EDIT Tr -
™:120.0(MAS) Timing:1/16 Tsig: 4/ 4Tsig: 4/ 4
Count:OFF Loop: ONLoop: ON Bars: 0Bars: 0
Tr:01-Track01 ON:YES Pgm:OFF
S:DRUM1:OFF New Pgm-A S:DRUM1:OFF New Pgm-A Velo%:100
Select the Timing: field with the CURSOR and set the quantize rate by rotating the DATA
wheel. The options are as follows:
OFF No timing correction. Moves the point by one tick each time the STEP < / > key
is pressed.
1/8 All notes are moved to the nearest 1/8-note (48 tick).
1/8(3) All notes are moved to the nearest 1/8-note triplet (32 tick).
1/16 All notes are moved to the nearest 1/16-note (24 tick).
1/16(3) All notes are moved to the nearest 1/16-note triplet (16 tick).
1/32 All notes are moved to the nearest 1/32-note (12 tick).
1/32(3) All notes are moved to the nearest 1/32-note triplet (8 tick).
It is also possible to make fine adjustments in the following Time Correction window.
CAUTION: Timing Correct is only valid for note events. Control Change or Pitch Bend will not be
time corrected.
To make fine adjustments in the Time Correct window, select the Timing: field with the CUR-
SOR key and press the OPEN WINDOW key.
..........................
CLOSE DO IT
Note value:Note value:1/16 Swing%:50
Shift timing:EARLIERShift timing:EARLIER amount: 0amount: 0
 Time:001.01.00-001.01-00
Notes:ALL (HIT pad)(HIT pad)
....................................................................................
....................................................................................
...................................................................................................
.......................................................................................................
............................
Timing CorrectTiming Correct
To time correct recorded data, set the following fields and press DO IT[F5]. Only the track
selected on the main screen will be time corrected.
•
Note Value:
This is the same as the Timing: field on the Main Screen.
•
Swing %:
This appears only when Note Value: is set to 1/8 or 1/16. Shift the note events of the
even beats at the ratio set here to add a swing to the rhythm.
•
Shift Timing:
This shifts the note event back or forward the number of ticks set in the amount: field
below.
EARLIER shifts forward
LATER shifts back