Chapter 9: Effects
Page 139
Multi-effects
The MPC2000XL has two multi-effects and each has five effect modules. You can execute vari-
ous routings by rearranging the modules. Select MULTI FX1 or FX2 in the Edit: field of
the FXedit screen and then select MIX with the CURSOR keys.
ON/OFFDRUM 2DRUM 2DRUM 1DRUM 1 DRUM 3DRUM 3 DRUM 4DRUM 4 SETUP
Drum:1 Pgm: 1-NewPgm-A
Edit:MULTI FX1
M1
REV MIX
DIST FILT MOD ECHO
Press OPEN WINDOW to open the Effect Mixer window.
........................
......................................................................................................
............................
CLOSE
Effect MixerEffect Mixer
Direct sig:Direct sig: ON
Patch:
MOD/ECHO REVMOD/ECHO REV
Output:L/R
Lev Pan WidLev Pan Wid
Dist/EQ:50 MIDDist/EQ:50 MID
Mod/Echo:50 MID 99Mod/Echo:50 MID 99
Reverb:40 MIDReverb:40 MID
......................
Direct sig: This turns the direct sound of the signal input to an effect on or off. When it is
ON, the level or pan of the direct sound is adjusted by the stereo mixer.
Patch: To set the effect routing.
Output: To select the output of the effect (left and right or individual outputs 1/2, 3/4, 5/6, 7/8).
Dist/EQ: This sets the output level and pan of the distortion and filter modules.
Mod/Echo: This sets the output level and pan of the modulation and delay/echo modules.
Wid adjusts the stereo range of the effect. When Wid is set to 0, the output effect sound
becomes monaural.
Reverb: This sets the output level and pan of the reverb module.
Setting the Effect Routing
Select the routing of the multi-effect in the Patch: field.
When MOD/ECHO4REV is selected
The signal flow is as follows:
DIST
FILT
MOD
ECHO
REV
M1/M2
Dist/Filt
Mod/Echo
Reverb
ON/OFFDRUM 2DRUM 2DRUM 1DRUM 1 DRUM 3DRUM 3 DRUM 4DRUM 4 SETUP
Drum:1 Pgm: 1-NewPgm-A
Edit:MULTI FX1
M1
REV MIX
DIST FILT MOD ECHO
To Next Page
Loading...
Need help?
General
