Chapter 10: Disk Operation
Page 165
Note: When SCSI is selected in the
Device:
field, the
Part:
field appears on
the screen.
SAVE FORMAT DO ITLOAD
View:ALL FilesALL Files
File:LOOP_1 .SND Size= 862K
Device:SCSI-1 Free Free memory
snd= 1900K
Type=MPC2000XL seq= 2624K
LOAD
.......................................................................................................................
Select the partition that you want to load from.
If you are using a disk with a large amount of disk space, such as a hard disk, it is easier
to manage the files by dividing the disk space into partitions (see "Formatting a SCSI
Drive").
If you are loading CD-ROM data used with the S1000 or S3000, the Vol: field will ap-
pear to the right of the View: field.
SAVE FORMAT DO ITLOAD
View:ALL FilesALL Files Vol:SUTUDIO_SET
File:LOOP_1 .SND Size= 862K
Device:SCSI-1 Free Free memory
snd= 1900K
Type=MPC2000XL seq= 2624K
LOAD
.......................................................................................................................
S1000 or S3000 disks are divided into partitions and then to smaller units called volume.
When you are selecting a file to load, select a partition in the Part: field, a volume in the
Vol: field, and the sound in the File: field.
You can select the file type you want to display in the File: field of View: field. It is
possible to select a specific extension in the View: field. This enables you to display
only the files with the extension selected in the View: field in the File: field. This is
convenient to find a file when there are many files on a disk.
3
Select the file you want to load in the File: field. The procedures differ slightly depend-
ing on the type of file selected.
4-1. Selecting .SND (sound) Files or .WAV (wave) Files
Press DO IT [F6] to load a sound file. The following window appears when loading is
completed.
........................
......................................................................................................
........................................................................................................
............................
DSCARD KEEPPLAY
Load s SoundLoad s Sound
File:HOUSE_TAMB
Assign to note:36/A02Assign to note:36/A02
The file name will appear in the File: field.
Press PLAY [F3] to listen to the sound.
Select the note number or drum pad that you want to assign the sound to in the Assign
to note: field. You can rotate the DATA wheel or select directly by playing the pad.
Select --/OFF by rotating the DATA wheel if you don't want to assign the sound to a
note number.
To Next Page
Loading...
Need help?
General
