Akai MPC2000XL

Chapter 10: Disk Operation
Page 171
The loaded sound can be played by pressing PLAY [F3].
Set the Note Number to be assigned in the Assign to note: field.
To save the sound, press KEEP [F5]. To delete the sound to free the memory, press DSCARD
[F4].
Loading a Sequence (.SEQ) File
Follow steps 1-3 in “Loading Files” and select the .SEQ file in step 3. Then press DO IT [F6].
The pad number recorded in the Sequence data of the MPC60/60II can now be converted to Note
Numbers on the MPC2000XL.
Select one of the pads of the MPC60/60II in the MPC60 Pad: field, and then select the Note
Number that you want to assign it to in the Becomes note: field, then press LOAD [F5].
Note:
When the sequence and sound files of the MPC60/60II are loaded and used at the same time,
it is necessary to match the settings of the conversion table to those of the sound set file.
Press DO IT [F6].
Loading an All (.ALL) File
Follow steps 1-3 in “Loading Files” and select the .ALL file in step 3. Then press DO IT [F6].
Then continue from step 4.
........................
......................................................................................................
........................................................................................................
............................
KEEPDSCARDPLAY
Load a SoundLoad a Sound
File:CLOSE_HAT
Assign to note:Assign to note:42/A03
........................
......................................................................................................
........................................................................................................
.................................................................................
............................
LOADCANCEL
Conversion tableConversion table
MPC60 pad:MPC60 pad:HIHT CLSD (A01)HIHT CLSD (A01)
Becomes note:42/A03Becomes note:42/A03
........................
......................................................................................................
........................................................................................................
............................
KEEPPLAY DSCARD
Load a SequenceLoad a Sequence
File:KOH__2 .SEQ
Load into: Load into:02-(Unused)