Page 46
Chapter 3: Recording Sequences
Setting the metronome sound, volume and output
When the “Count/Metronome” window is displayed (see previous section), pressing “SOUND”
(F5) opens the “Metronome sound” window where you can select sounds and output for the
metronome.
Sound:
Here you can select a metronome sound CLICK, DRUM 1, 2, 3 or 4.
By selecting DRUM 1-4, the metronome function can be used using the internal drum sounds.
If CLICK is selected, the following will be displayed.
Volume:
This sets the volume level of the metronome.
Output:
This sets where the sound of the metronome will be output from:
STEREO, from the STEREO OUT/HEADPHONE jacks.
OUT 1 – 8 , from the optional ASSIGNABLE MIX OUT jacks.
If you select DRUM1, 2, 3 or 4 in the Sound: field, you can select 2 drum sounds (Accent
and Normal) that will play as the metronome sound. You can select the sounds by pressing one
of the drum pads or selecting the sound in the corresponding field.
The velocity level of the sounds can be adjusted in the Velocity: fields.
........................
CLOSE
Sound: CLICK
Volume:100
Output:STEREO
....................................................................................
............................
Metronome SoundMetronome Sound
........................
CLOSE
Sound: DRUM4
Accent:37/A01 :127
Normal:37/A01 : 64
Velocty
....................................................................................
............................
Metronome SoundMetronome Sound
To Next Page
Loading...
Need help?
General
