Version 1.21 139
s5000
/
s6000
EDIT PROGRAM
KNOWN PROBLEMS WITH MIDI PROGRAM CHANGE
This scheme is far from foolproof and there are some problems associated with program
change. Some are unique to samplers whilst others are common to all sound modules. These
are listed here:
• If two programs share the same program number and you select that program number via
a MIDI program change command, the first program found will be selected.
• If several parts share the same MIDI channel and a program change command is sent on
that channel, all parts will select the one sound which will appear in all four parts.
• If a program is renumbered (perhaps because another program has that program number),
you will need to change the program change number on the sequencer.
• If SAVE MULTI+PROGS+SAMPS is used, programs ‘outside’ the multi that are intended
for remote selection via MIDI will not be saved and so it will be necessary to save these
separately (or to load them in separately next time you load the multi).
If you try any of the above routines and no programs are loaded, you will receive this prompt:
You are offered the option to create one. To cancel the prompt, simply press NO (F8).
To Next Page
Loading...
Need help?
General
