48 Version 1.21
MULTI
s5000
/
s6000
EFFECTS SEND WINDOW
The parameters are:
EFFECTS CHANNEL You may select OFF, FX 1, FX 2 (the two multiFX channels), RV3 or
RV4 (the two reverb only channels).
EFFECTS SEND This is a duplication of the main EFFECTS SEND parameter.
NOTE 1: It is also possible to send individual keygroups to the FX. This can be useful in, say,
a drums program where each individual drum can have its own effect type and send level. Of
course, other types of programs may also use this function.
This is mentioned here simply because you may load a sound, assign it to a part, set the
effects channel and send level in this window but get unpredictable results. For example, you
may load something, route it to RV4 but find that multiFX1 is applied. The reason for this will
almost undoubtedly be that the original programmer assigned the program’s keygroups to
multiFX1 in EDIT PROGRAM (for some reason!).. If you do experience this, go to EDIT PART
(or EDIT PROGRAM) and check the OVERIDE FX parameter in the main KEYGROUP page.
NOTE 2: On the S5000, even if the EB20 is not installed, you still have access to these
parameters even though they have no function.
To Next Page
Loading...
Need help?
General
