Name: Akai S5000
Brand: Akai
Rating: 4 (1 reviews)

To Next Page

To Previous Page

210 Version 1.21

s5000

s6000

OUTPUT MIX (MULTIFX1 AND 2 ONLY)

Pressing OUTPUT MIX in the main MULTIFX page shows this screen:

Here you may balance the various multiFX sections. The parameters are:

DIST/EQ LEVEL Sets the output level of the RING MOD/DISTORTION/EQ block of effects.

DIST/EQ PAN Sets the pan position of the RING MOD/DISTORTION/EQ block of

effects.

MOD/DEL LEVEL Sets the level of the MODULATION/DELAY effects.

MOD/DEL PAN Sets the stereo balance of the MODULATION/DELAY effects.

MOD/DEL WIDTH Sets the width of the stereo image. At a value of 100, maximum stereo is

obtained but set lower than that and the sound becomes gradually

narrower. At a value of 0, the output from the MODULATION/DELAY

section is mono.

REVERB LEVEL This sets the level of the reverb in the multiFX chain.

REVERB PAN This sets the stereo balance of the reverb in the multiFX chain.

NOTE: REVERB LEVEL and REVERB PAN are duplications of the parameters found in the

main reverb pages and are included here for convenience.

DIRECT SIGNAL You can switch out the direct signal from the multiFX chain. This is of

most relevance when using effects such as autopan or rotary speakers

although it can be useful in other circumstances.

Questions and Answers:

Need help?

Do you have a question about the Akai S5000 and is the answer not in the manual?

Akai S5000 Specifications

General