A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
6.3. LED Setting
6.3.1. Configure Card Reader LED Setting
You can enable or disable the LED lighting on the card reader area as needed
on the web interface. Meanwhile, If you do not want to have the LED light on
the card reader area to stay on, you can also set the timing for the exact time
span during which the LED light can be disabled in order to reduce the
electrical power consumption. To configure the configuration on web
Setting > Time/Lang > Time Interface.
Parameter Set-up:
Enabled: Tick the check box if want to enable the card reader LED lighting
and vice versa.
Start Time - End Time (H): enter the time span for the LED lighting to be
valid, e.g., if the time span is from 18-22 it means LED light will stay on
during the time span from 6:00 pm to 10:00 pm in one day (24 hours).
6.3.2. Configure LED White Light Setting
LED White light is used to reinforce the lighting for facial recognition as well
as for the QR code access as needed in the dark environment. To configure
the configuration on web Device > Light > White Light interface
To Next Page
Loading...
