Akuvox A05 Series - Relay Setting; Relay switch setting

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
19
 Discovery Mode: click “Enabled” to turn on the discovery mode of the
device so that it can be discovered by other devices in the network and
click “Disabled” if you want to conceal the device so as not to be
discovered by other devices.
 Device Address: specify the device address by entering device location
information from the left to the right: Community, Unit, Stair, Floor, Room
in sequence.
 Device extension: enter the device extension number for the device you
installed
 Device Location: enter the location in which the device is installed and
used.
7.3. Relay Setting
You can configure the relay switch(es) and DTMF for the door access on the
web interface.
7.3.1.Relay switch setting
To configure the configuration on web Access Control > Relay > Relay
interface.