Akuvox A05 Series - Web Relay Setting; Configure Web Relay on the Web Interface

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
20
Parameter Set-up:
 Trigger Delay (Sec): set the relay trigger delay timing (Ranging from 1-10
Sec.) For example, if you set the delay time as “5” sec. then the relay will
not be triggered until 5 seconds after you press “unlock” tab.
 Hold Delay (Sec): set the relay hold delay timing (Ranging from 1-10 Sec.)
For example, if you set the hold delay time as “5” Sec. then the relay will
be delayed for 5 after the door is unlocked.
 Relay Status: relay status is low by default which means normally closed
(NC) If the relay status is high, then it is in Normally Open status (NO).
 Relay Name: name the relay switch according to your need. For example,
you can name the relay switch according to where the relay switch is
located for the convenience.
Note:
 Only the external devices connected to the relay switch needs to be
powered by power adapters as relay switch does not supply power.