Akuvox A05 Series - Configure Facial Recognition on Web Interface

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
27
9.1.1.1. Configure RF Card Code Format
If you want to integrate with the third-party intercom system in terms of RF
card door access, you can change the RF card code format to be identical
with that applied in the third-party system. To configure the configuration on
web Access Control > CardSetting interface.
Parameter Set-up:
 IC-Card Display Mode: select the card format for the ID Card for the door
access among five format options: 8H10D; 6H3D5D(W26); 6H8D; 8HN;
8HR. The card code format is 8HN by default in the access control
terminal.
9.1.2.Configure Facial Recognition on Web Interface
To configure the configuration on web Access Control > User interface.
Parameter Set-up:
 Status: It will show “Registered” when the picture uploaded conforms to
the format and standard otherwise it would show “Unregistered” as the
default. However, the status will be changed back to “Unregistered” if the