Akuvox A05 Series - Security; Tamper Alarm Setting; Security Notification Methods

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
36
10. Security
10.1.Tamper Alarm Setting
Tamper alarm function serves as a protection against any unauthorized
removal of the devices by triggering off the temper alarm on the device. To
configure the configuration on web Security > Basic > Temper Alarm
interface.
Parameter Set-up:
 Enable: tick the check box to enable the temper alarm function. When the
temper alarm goes off, you can press the Disarm tab beside the check
box to clear the alarm.
 Key Status: temper alarm will not be triggered unless the key status is
shifted from “Low” to “High” status.
Note:
 Disarm tab will turn gray when the temper alarm is cleared.
 The round rubber button at the back of the device must be in
press-down status otherwise the alarm will not be fired.