Akuvox A05 Series - Body Temperature Measurement for Door Access（Optional; Body Temperature Measurement Configuration

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
33
9.3.5. Body Temperature Measurement for Door
Access（Optional）
A05 series provide you with an optional body temperature measurement
function designed to be applied in the situation where the measurement
becomes necessary for the safety of the residents and visitors etc. Residents
and visitors are required to go through temperature measurement along with
optional mask detection check before they are allowed for the door access.
9.3.5.1. Body Temperature Measurement Configuration
You can configure the body temperature measurement function in terms of
defining the normal temperature as well as making schedule for the validity
of the function etc. To configure the configuration on web Access Control >
Body Temperature > Measuring Body Temperature interface.
Parameter Set-up:
 Mode: select either “Disabled” Mode or “Wrist” Mode for temperature
measurement according to your need. The device can be installed with
digital forehead temperature detector therefore you are required to set
the mode properly according to your application.
 Mask Detection: select “Enable” or” Disable” to turn on or turn off the
mask detection. When enabled, the device will check if the visitor is