Akuvox A05 Series - Unlock by HTTP Command on Web Browser

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
30
used together with Akuvox SmartPlus. You can shake the mobile phone
closer to the access control terminal for the door access. To configure the
configuration on web Access Control > BLE > BLE interface.
Parameter Set-up:
 Enabled: enable or disable the Bluetooth function. Bluetooth is turned off
by default.
 Rssi Threshold: select the signal receiving strength from -85~-50db in
absolute terms. The higher value it is, the greater strength it has. The
default value is 72db in absolute terms.
 Open Door Interval: select the time interval between every two Bluetooth
door accesses.
9.3.3. Unlock by HTTP Command on Web Browser
You can unlock the door remotely without approaching the device physically
for the door access by typing in the created the HTTP command (URL) on the
web browser to trigger the relay when you are not available by the door for
the door access. To configure the configuration on web Access Control >
Relay > Open Relay via HTTP interface.