Akuvox A05 Series - Integration with Third Party Device; Integration via Wiegand

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
59
17. Integration with Third Party Device
17.1.Integration via Wiegand
If you want to integrate the A05 series access control terminal with the
third-party devices via Wiegand, you can configure the Wiegand on the web
Device > Wiegand > Wiegand interface.
Parameter Set-up:
 Wiegand Display Mode
：
select Wigand Card code format among 8H10D;
6H3D5D; 6H8D; 8HN; 8HR; RAW.
 Wiegand Card Reader Mode: set the Wiegand data transmission format
among three options: Wiegand 26, Wiegand 34, Wiegand 58. The
transmission format should be identical between the access control
terminal and the device to be integrated.
 Wiegand Transfer Mode: set the transfer mode between Input or Output if
the access control terminal is used as a receiver, then set it as “Input” for
the access control terminal and vice versa.
 Wiegand Input Data Order
：
set the Wiegand input data sequence between
Normal and Reversed if you select Reversed then the input card number