Akuvox A05 Series - OSDP Setting

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
61
17.3. OSDP Setting
If you choose OSDP integration mode, you can not only check for OSDP
status but also obtain the authentication from the third-party devices for
various applications such as door access etc. To configure the configuration
on web Device > RS485 > OSDP Advance Setting interface.
Parameter Set-up:
 Connect Status: indicate OSDP based communication status.
 Send by: select in what way you want to send out the card number
among three options: OSDP, Wiegand and None. if you select OSDP then
the card number will be sent out to the third-party devices via RS485. if
you select “Wiegand” then the card number will be sent out via wiegand.
If you select “None” then the card number will not be sent out but
retained in the system.
Note:
 Dummy card numbers cannot be sent if “OSDP” is not selected in
the RS485 list field.