Akuvox A05 Series - RTSP Stream Setting

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
43
 Password: enter the password for RTSP authorization.
11.3.2. RTSP Stream Setting
You can select the video codec format for the RTSP stream for the
monitoring and you can also configure video resolution and bitrate etc. which
based on your actual network environment on the web interface. To
configure the configuration on web Surveillance > RTSP > H.264 Video
Parameters interface.
Parameter Set-up:
 Video Resolution: select video resolutions among seven options: “QCIF”,
“QVGA”, “CIF”, “VGA”, “4CIF”, “720P,”, and
“
1080P”. The default video
resolution is “720P. and the video from the access control terminal might
not be able to be shown in the indoor monitor if the resolution is set
higher than “720P”.
 Video Framerate: “25fps” is the video frame rate by default.
 Video Bitrate: select video bitrate among six options: “128 kbps”,
“256kbps”, “512 kbps”, “1024 kbps”, “2048 kbps”, “4096 kpbs”
according to your network environment. The default video bitrate is
“2048 kpbs”.
 2nd Video Resolution2: select video resolution for the second video
stream channel. While the default video solution is “VGA”.