Akuvox A05 Series - Web Relay Setting; Configure Web Relay on the Web Interface

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
21
7.4. Web Relay Setting
In additional to the relay that is connected to the access control terminal, you
can also control the door access using the network-based web relay on the
device and on the device web interface.
7.4.1.Configure Web Relay on the Web Interface
Web relay needs to set up on the web interface where you are required to fill
in such information as relay IP address, password, web relay action etc.
Before you can achieve the door access via web relay. To configure the
configuration on web Access Control > Web Relay interface.
Parameter Set-up:
 Type: select among three options Disabled, WebRelay and Both. Select
WebRelay to enable the web relay. Select Disable to disable the web relay.
Select Both to enable both local relay and web relay.