Akuvox A05 Series - Static Provisioning Configuration

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
56
configuration or upgrading.
 DHCP Option 66: If none of the above is set, the device will automatically
use DHCP Option 66 for getting the upgrade server URL. This is done
within the software and the user does not need to specify this. To make it
work, you need to configure the DHCP server for the option 66 with the
update server URL in it.
 DHCP Option 43: If the device does not get an URL from DHCP Option 66,
it will automatically use DHCP Option 43. This is done within the software
and the user does not need to specify this. To make it work, you need to
configure the DHCP server for the option 43 with the update server URL in
it.
Note:
 The general configuration file for the in-batch provisioning is with the
format “r0000000000xx.cfg” taking A05 as an example
“r000000000105.cfg (10 “zeros” in total while the MAC-based
configuration file for the specific device provisioning is with the
format”, MAC_Address of the device.cfg, for example
“0C110504AE5B.cfg.”
16.5.Static Provisioning Configuration
You can manually set up a specific server URL for downloading the firmware
or configuration file. If an autop schedule is set up, the access control
terminal will perform the auto provisioning on a specific timing according to
autop schedule you set up. In addition, TFTP, FTP, HTTP, and HTTPS are the
protocols that can be used for upgrading the device firmware and
configuration. To download the Autop template on Upgrade > Advanced >
Automatic Autop , and setup Autop server on Upgrade > Advanced > Manual
Autop interface.