Akuvox A05 Series - Screen Display configuration; Configure Screensaver

A05 Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
12
Parameter Set-up:
 Mode: select “Auto” or “OFF”. If you select “Auto” then the white light will
turn on for 5 minutes for facial recognition and QR code scan. And if you
select “Off” then the white light will be turned off.
 Max White Light Value: set the white light value from 1-5, and the default
white light value is “3”. The greater value it is, the brighter the light will
be.
Note:
 IR LED light should be triggered first before the white light can be
valid in the facial recognition, however IR LED light does not need
to be triggered for the white light function in the QR code scan.
6.4. Screen Display configuration
A05 series access control terminals allow you to enjoy a variety of screen
displays to enrich your visual and operational experience through the
customized setting to your preference.
6.4.1. Configure Screensaver
Await screen is mainly a function for the screen protection. You can make the
device to go into idle status for a predefined time span when there is no
operation on the device, or no one is detected approaching.