PWRADJFAIL (Power Adjustment Failure)
Corrective Action
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
If... Then...
the system is equipped with the
SFD40/SFD40B,
continue with Step 2.
the
system is not equipped with the
SFD40/SFD40B,
proceed to Step 6.
...................................................................................................................................................................................................
2
On the FOADM terminal with SFD40/SFD40B packs (see “Provisioning an
SFD40/SFD40B in a FOADM node” (p. 3-55)), check the alarm status of the
SFD40/SFD40B.
CLI alm
WEBUI Select Reports > Alarm List >Total.
Note the SFD40/SFD40B status by monitoring the temperature LED of the
SFD40/SFD40B. The SFD40/SFD40B should in service when the temperature and
initialization LEDs turn green. Also check the alarm status on the NE management
software to ensure that the housekeeping cable has been properly connected.
...................................................................................................................................................................................................
3
If the SFD40/SFD40B has been initialized, and has a temperature alarm, delete all the
optical channel services and turn off OTU lasers connected to SFD40/SFD40B.
Trouble-clearing procedures
PWRADJFAIL
PWRADJFAIL (Power Adjustment Failure)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-259
To Next Page
Loading...
