Alcatel-Lucent 7210 SAS M Interface Configuration Guide

802.1x Port Commands
Page 174 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
The no form of this command removes the RADIUS policy association.
Default no radius-plcy
Parameters name — Specifies an existing 802.1x RADIUS policy name.
re-auth-period
Syntax re-auth-period seconds
no re-auth-period
Context config>port>ethernet>dot1x
Description This command configures the period after which re-authentication is performed. This value is only relevant
if re-authentication is enabled.
The no form of this command returns the value to the default.
Default 3600
Parameters seconds — The re-authentication delay period in seconds.
Values 1 — 9000
re-authentication
Syntax [no] re-authentication
Context config>port>ethernet>dot1x
Description This command enables / disables periodic 802.1x re-authentication.
When re-authentication is enabled, the 7210 SAS will re-authenticate clients on the port every re-auth-
period seconds.
The no form of the command returns the value to the default.
Default re-authentication
server-timeout
Syntax server-timeout seconds
no server-timeout
Context config>port>ethernet>dot1x
Description This command configures the period during which the 7210 SAS waits for the RADIUS server to responds
to its access request message. When this timer expires, the 7210 SAS will re-send the access request
message, up to the specified number times.
The no form of this command returns the value to the default.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English