Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 175
Default 30
Parameters seconds — The server timeout period in seconds.
Values 1 — 300
supplicant-timeout
Syntax supplicant-timeout seconds
no supplicant-timeout
Context config>port>ethernet>dot1x
Description This command configures the period during which the 7210 SAS waits for a client to respond to its EAPOL
messages. When the supplicant-timeout expires, the 802.1x authentication session is considered to have
failed.
The no form of this command returns the value to the default.
Default 30
Parameters seconds — The server timeout period in seconds.
Values 1 — 300
transmit-period
Syntax transmit-period seconds
no transmit-period
Context config>port>ethernet>dot1x
Description This command configures the period after which the 7210 SAS sends a new EAPOL request message.
The no form of this command returns the value to the default.
Default 30
Parameters seconds — The server transmit period in seconds.
Values 1 — 3600
down-when-looped
Syntax down-when-looped
Context config>port>ethernet
Description This command configures Ethernet loop detection attributes.
To Next Page
Loading...
