Port Commands
Page 180 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
Port Commands
network
Syntax network
Context config>port>ethernet
Description This command enables access to the context to configure network port parameters.
uplink
Syntax uplink
Context config>port>access
config>port>ethernet>access>uplink
Description This command enables the context to configure access uplink port parameters.
accounting-policy
Syntax accounting-policy policy-id
no accounting-policy
Context config>port>ethernet>network
config>port>ethernet>access>uplink
Description This command configures an accounting policy that can apply to an interface.
An accounting policy must be configured before it can be associated to an interface. If the accounting
policy-id does not exist, an error is returned.
Accounting policies associated with service billing can only be applied to SAPs. Accounting policies
associated with network ports can only be associated with interfaces. Only one accounting policy can be
associated with an interface at a time.
The no form of this command removes the accounting policy association from the network interface, and the
acccounting policy reverts to the default.
Default No accounting policies are specified by default. You must explicitly specify a policy. If configured, the
accounting policy configured as the default is used.
Parameters policy-id — The accounting policy-id of an existing policy. Accounting policies record either service
(access) or network information. A network accounting policy can only be associated with the network
port configurations. Accounting policies are configured in the config>log>accounting-policy context.
Values 1 — 99
To Next Page
Loading...
Need help?
General
