Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 181
collect-stats
Syntax [no] collect-stats
Context config>port>ethernet>network
config>port>ethernet>access>uplink
Description This command enables the collection of accounting and statistical data for the network interface. When
applying accounting policies, the data, by default, is collected in the appropriate records and written to the
designated billing file.
When the no collect-stats command is issued, the statistics are still accumulated by the cards, however, the
CPU does not obtain the results and write them to the billing file.
If the collect-stats command is issued again (enabled), then the counters written to the billing file will
include the traffic collected while the no collect-stats command was in effect.
Default no collect-stats
queue-policy
Syntax queue-policy name
no queue-policy
Context config>port>ethernet>access>uplink
config>port>ethernet>access>network
Description This command specifies the existing network queue policy which defines queue parameters such as CIR and
PIR rates, as well as forwarding-class to queue mappings. The network-queue policy is defined in the
config>qos>network-queue context.
Default default
Parameters name — Specifies an exisiting network-queue policy name.
To Next Page
Loading...
Need help?
General
