Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 197
standby-signalling
Syntax standby-signalling {lacp | power-off}
no standby-signalling
Context config>lag
Description This command specifies how the state of a member port is signalled to the remote side when the status
corresponding to this member port has the standby value.
Default lacp
Parameters lacp — Specifies that LACP protocol is used to signal standby links of the LAG.
power-off — The laser of the standby links in the LAG are shutoff to indicate "standby" status. It allows
user to use LAG standby link feature without LACP, if the peer node does not support LACP.
To Next Page
Loading...
