Alcatel-Lucent 7210 SAS M - Page 203

Ethernet Ring Commands
Page 198 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
Ethernet Ring Commands
eth-ring
Syntax eth-ring ring-id
no eth-ring
Context config
Description This command configures a G.8032 protected Ethernet ring. G.8032 Rings may be configured as major rings
with two paths (a&b).
The no form of this command deletes the Ethernet ring specified by the ring-id.
Default no eth-ring
Parameters ring-id — Specifies the ring ID.
Values 1—128
description
Syntax description description-string
no description
Context config>eth-ring
Description This command adds a text description for the ring. The no form of this command removes the text
description.
Default “Eth ring”
Parameters string — Specifies the text description up to 160 characters in length.
guard-time
Syntax guard-time time
no guard-time
Context config>eth-ring
Description This command configures the guard time for an Eth-Ring. The guard timer is standard and is configurable
from “x”ms to 2 seconds
The no form of this command restores the default guard-time.
Default 5 deciseconds
Parameters value — Specifies the guard-time.