Multi-Chassis Redundancy Commands
Page 214 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
source-address
Syntax source-address ip-address
no source-address
Context config>redundancy>multi-chassis>peer
Description This command specifies the source address used to communicate with the multi-chassis peer.
Parameters ip-address — Specifies the source address used to communicate with the multi-chassis peer.
peer-name
Syntax peer-name name
no peer-name
Context config>redundancy>multi-chassis>peer
Description This command specifies the peer name used to communicate with the multi-chassis peer.
Parameters name — Specifies the name used to communicate with the multi-chassis peer.
sync
Syntax [no] sync
Context config>redundancy>multi-chassis>peer
Description This command enables the context to configure synchronization parameters.
igmp-snooping
Syntax [no] igmp-snooping
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether IGMP snooping information should be synchronized with the multi-
chassis peer.
Default no igmp-snooping
To Next Page
Loading...
