Alcatel-Lucent 7210 SAS M - Page 220

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 215
port
Syntax port [port-id | lag-id] [sync-tag sync-tag]
no port [port-id | lag-id]
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies the port to be synchronized with the multi-chassis peer and a synchronization tag to
be used while synchronizing this port with the multi-chassis peer.
Parameters port-id — Specifies the port to be synchronized with the multi-chassis peer.
lag-id — Specifies the LAG ID to be synchronized with the multi-chassis peer.
sync-tag sync-tag — Specifies a synchronization tag to be used while synchronizing this port with the
multi-chassis peer.
range
Syntax range encap-range sync-tag sync-tag
no range encap-range
Context config>redundancy>multi-chassis>peer>sync>port
Description This command configures a range of encapsulation values.
Parameters Values encap-range
Specifies a range of encapsulation values on a port to be synchronized with a multi-chassis peer.
Values Dot1Q start-qtag-end-qtag
start-qtag [0..4094]
end-qtag [0..4094]
QinQ - <qtag1>.<start-qtag2>-<qtag1>.<end-qtag2>
- <start-qtag1>.*-<end-qtag1>.*
qtag1 [1..4094]
start-qtag1 [1..4094]
end-qtag1 [1..4094]
start-qtag2 [0..4094]
end-qtag2 [0..4094]
sync-tag sync-tag — Specifies a synchronization tag up to 32 characters in length to be used while
synchronizing this encapsulation value range with the multi-chassis peer.