Alcatel-Lucent 7210 SAS M - Page 260

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 255
-------------------------------------------------------------------------------
Unicast Packets 0 0
Multicast Packets 0 0
Broadcast Packets 0 0
Discards 0 0
Unknown Proto Discards 0
===============================================================================
===============================================================================
Ethernet-like Medium Statistics
===============================================================================
Alignment Errors : 0 Sngl Collisions : 0
FCS Errors : 0 Mult Collisions : 0
SQE Test Errors : 0 Late Collisions : 0
CSE : 0 Excess Collisns : 0
Too long Frames : 0 Int MAC Tx Errs : 0
Symbol Errors : 0 Int MAC Rx Errs : 0
===============================================================================
*A:7210SAS>show#
Specific Por t Output Fiel ds Specific Port Output — The following table describes port output fields for a specific port.
Label Description
Description
A text description of the port.
Interface
The port ID displayed in the slot/mda/port format.
Speed
The speed of the interface.
Link-level
Ethernet — The port is configured as Ethernet.
MTU
The size of the largest packet which can be sent/received on the Ether-
net physical interface, specified in octets.
LoopBack Mode Indicates if the port is in use by loopback mac-swap application. If
'None' is displayed the port is not enabled for loopback testing. If
'Internal' is displayed, the port is in use by port loopback mac-swap
application and no services can be configured on this port.
Admin State
Up — The port is administratively up.
Down — The port is administratively down.
Oper State
Up — The port is operationally up.
Down — The port is operationally down.
Additionally, the lag-id of the LAG it belongs to in addition to the
status of the LAG member (active or standby) is specified.