Alcatel-Lucent 7210 SAS M Interface Configuration Guide

Port Show Commands
Page 256 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
Duplex
Full — The link is set to full duplex mode.
Half — The link is set to half duplex mode.
Hold time up
The link up dampening time in seconds. The port link dampening timer
value which reduces the number of link transitions reported to upper
layer protocols.
Hold time down
The link down dampening time in seconds. The down timer controls
the dampening timer for link down transitions.
Physical Link
Yes — A physical link is present.
No — A physical link is not present.
IfIndex
Displays the interface's index number which reflects its initialization
sequence.
Last State chg
Displays the system time moment that the peer is up.
Configured Mode
network — The port is configured for transport network use.
access — The port is configured for service access.
Dot1Q Ethertype
Indicates the Ethertype expected when the port's encapsulation type is
Dot1Q.
QinQ Ethertype
Indicates the Ethertype expected when the port's encapsulation type is
QinQ.
Net. Egr. Queue
Pol
Specifies the network egress queue policy or that the default policy is
used.
Access Egr. Qos
Specifies the access egress policy or that the default policy 1 is in use
Egr. Sched. Pol
Specifies the port scheduler policy or that the default policy default is
in use
Encap Type
Null — Ingress frames will not use any tags or labels to delineate a
service.
dot1q — Ingress frames carry 802.1Q tags where each tag signifies
a different service.
QinQ — Encapsulation type specified for QinQ Access SAPs.
Active Alarms
The number of alarms outstanding on this port.
Auto-negotiate
True — The link attempts to automatically negotiate the link speed
and duplex parameters.
False — The duplex and speed values are used for the link.
Alarm State
The current alarm state of the port.
Label Description (Continued)

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English