Alcatel-Lucent 7210 SAS M - Page 295

Port Show Commands
Page 290 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
Sample Output
===============================================================================
Ethernet Statistics
===============================================================================
Broadcast Pckts : 2 Drop Events : 0
Multicast Pckts : 15863 CRC/Align Errors : 0
Undersize Pckts : 0 Fragments : 0
Oversize Pckts
The total number of packets received that were longer than can be
accepted by the physical layer of that port (9900 octets excluding fram
-
ing bits, but including FCS octets for GE ports) and were otherwise
well formed.
Collisions
The best estimate of the total number of collisions on this Ethernet seg-
ment.
Drop Events
The total number of events in which packets were dropped by the
probe due to lack of resources. Note that this number is not necessarily
the number of packets dropped; it is just the number of times this con
-
dition has been detected.
CRC Align Errors
The total number of packets received that had a length (excluding
framing bits, but including FCS octets) of between 64 and 1518 octets,
inclusive, but had either a bad Frame Check Sequence (FCS) with an
integral number of octets (FCS Error) or a bad FCS with a non-integral
number of octets (Alignment Error).
Fragments
The total number of packets received that were less than 64 octets in
length (excluding framing bits but including FCS octets) and had either
a bad Frame Check Sequence (FCS) with an integral number of octets
(FCS Error) or a bad FCS with a non-integral number of octets (Align
-
ment Error).
Jabbers
The total number of packets received that were longer than 1518 octets
(excluding framing bits, but including FCS octets), and had either a
bad Frame Check Sequence (FCS) with an integral number of octets
(FCS Error) or a bad FCS with a non-integral number of octets (Align
-
ment Error).
Ingress Pool
Size
The amount of ingress buffer space, expressed as a percentage of the
available buffer space that will be allocated to the port for ingress buff
-
ering.
Octets
The total number of octets received.
Packets
The total number of packets received.
Packets to
The number of packets received that were equal to or less than the dis-
played octet limit.
Label Description (Continued)