Alcatel-Lucent 7210 SAS M Interface Configuration Guide

Port Show Commands
Page 314 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
===========================================================================
Internal Loopback Port Status
===========================================================================
Port Loopback Application Service Speed Type
Id Type Enabled 1G/10G
---------------------------------------------------------------------------
1/1/3 Virtual Not-In-Use No 1G
2/1/3 Virtual Not-In-Use No 1G
3/1/3 Virtual Not-In-Use No 1G
4/1/3 Virtual Not-In-Use No 1G
========================================
Mac-swap Application Status
========================================
Enabled : No
Test Service Id : None
Test Sap Id : None
========================================
===========================================================================
*A:7210SAS>show>system#
Mac-swap Application Status — The following table describes Mac-swap Application Status
associations output fields.
Label Description
LoopBack Type The Loopback type indicates whether the port is in Physical Front
panel port or Internal Virtual port.
Application Application mentions the application in use of the port.
Service enabled The Service enabled displays, if services can be configured over this
port.
Enabled Displays the current status.
Test Service Id The service ID that is used in the configuration of Mac-swap test.
Test Sap Id The SAP ID that is used to configure the loopback SAP for the Mac-
swap application.
Loopback Src
Addr
The source MAC address that is used in the configuration of port
loopback mac-swap test.
Loopback Dst
Addr
The destination MAC address that is used in the configuration of port
loopback mac-swap test.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English