Alcatel-Lucent 7210 SAS M - Page 318

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 313
Test Sap Id : 1/1/12:90
Loopback Src Addr : 00:00:01:00:02:00
Loopback Dst Addr : 00:00:01:00:03:00
========================================
===============================================================================
*A:7210SAS>config>port#
Sample Output for 7210 SAS-T
A:SAST-1# show system internal-loopback-ports detail
===============================================================================
Internal Loopback Port Status
===============================================================================
Port Loopback Application Service
Id Type Enabled
-------------------------------------------------------------------------------
1/1/27 Virtual Not-In-Use No
1/1/28 Virtual Not-In-Use No
========================================
Mac-swap Application Status
========================================
Enabled : No
Test Service Id : None
Test Sap Id : None
========================================
Sample Output for 7210 SAS-X
A:SASX# show system internal-loopback-ports detail
===============================================================================
Internal Loopback Port Status
===============================================================================
Port Loopback Application Service
Id Type Enabled
-------------------------------------------------------------------------------
1/1/10 Physical Mac-Swap No
1/1/11 Physical Testhead No
========================================
Mac-swap Application Status
========================================
Enabled : Yes
Test Service Id : None
Test Sap Id : None
========================================
==========================================================
Sample Output for 7210 SAS-R6 and 7210 SAS-R12
*A:7210SAS>show>system# internal-loopback-ports detail